1. FreePBX Commercial
2. sipstation
3. source strings
4. review

%s Route(s) updated

%u

'Enable TLS' for 'Chan SIP' is currently set to '%s', this must be changed to '%s', change this %s and refresh this page

'SSL Method' for 'Chan SIP' is currently set to '%s', this must be changed to '%s', change this %s and refresh this page

Account Information

Account Key

Account Services

Add Key

Added New Trunks. Please hit Apply Config to apply the new settings

Added Routes

Adding new 844 toll free route

Additional E911 Addresses

Address 1

Address 2

Address On Record

Address1:

Address2:

All route areacodes updated

Allow SMS

An Error occurred trying run firewall test

An Error occurred trying to contact the server for account settings.

An unexpected token was returned, try the test again

Are you sure you want to cancel your Free Trial Account?

Area Code

Assign which users will get SMSes routed through this inbound route

Asterisk Registration Status

Automatically set the extension's CID to match the DID, if this DID is routed to an extension.

Caller ID

Caller ID For this DID

Caller ID for Emergency calls

Caller Name:

Cancel Free Trial

Chan_PJSIP has been enabled because this system is in PJSIP only mode

Chan_PJSIP is not supported on PBX 13.0 or lower

Chan_PJSIP is not supported when SIP Driver is forced to Chan_SIP

Channels

Check Connectivity

Check Primary (%s) and Secondary (%s) Trunk for each route that should be configured with the %s service. The trunks will be inserted into the corresponding routes upon clicking the %s button. You can enable 7 digit dialing with the trunk by entering your area code as well.

Checking routes for trunks..

City

City:

Clear Failover

Close

Codec Priorities

Connectivity

DID

DID Updates

DID Verification

DID not found

DID not provided